1. how many symbols we have in form tolerances?
a.1 b.2 c.3 d.4
2. which relation we can use to show a component is straight?
a. stright ness b.Roundness
c.Cylindricity d.Run
out
3. Which parameter we have to consider when we are deleaing
with Round ness?
a. cross section b. Axial length c. Both d. None of the above
4. Which parameter we have to consider when we are dealing
with cylindricity?
a. cross section b. Axial length c.
Both d. None of the above
5. Which parameter we
have to consider when we are dealing with run out?
a. cross section b. Axial length c. Both d. None of the above
6. Which parameter we have to consider when we are dealing with total run out?
a. cross section b. Axial length c.
Both d. None of the above
7. How many datum's we can take for a component?
a.1 b.2 c.3 d.4
8. How many material conditions we can give in Gd&t?
a.1 b.3 c.4 d.5
9. How many symbols we have in run out tolerances?
a.1 b.2 d.3 d.4
10. How many datum's we have to give for parallelism relation?
a.1 b.2 c.3 d.4
No comments:
Post a Comment